Orbit motors convert hydraulic energy (pressure, oil flow) into mechanical energy (torque, speed). Hydraulic orbit
motors operate on the principle of an internal gear (rotor) rotating within a fixed external gear (stator). The internal gear
transmits the torque generated by the application of pressure from hydraulic oil fed into motor which is then delivered via
the motor's output shaft. Orbit motors have high starting torque and constant output torque at wide speed range.
SPOOL VALVE TYPE:
MM, MP, MR, MH, PL, RL, PK, RK, RW, HW series motors have spool valve: the distributor valve has been integrated
with the output shaft. The cardan shaft rotates distributor valve and transfers mechanical energy from gerotor set to
output shaft. The valve has hydrodynamic bearings and has infinite life when load ratings are not exceeded.
DISTRIBUTOR VALVE TYPE:
MS,MT,MV series motors have disk valve: the distributor valve has been separated from output shaft and is driven by short
cardan shaft. A balance plate counterbalances the hydraulic forces around the distributor valve. It gives the motors high
efficiency- even at high pressures, and good starting characteristics.
|MM||Gerotor||8,2-50||Up to 140||Up to 2440||Up to 58||Download|
|MP||Gerotor||25-623,6||Up to 175||Up to 1815||Up to 640||Download|
|MR||Roll-Gerotor||50-397||Up to 200||Up to 970||Up to 690||Download|
|MH||Roll-Gerotor||201,3-502,4||Up to 200||Up to 445||Up to 1040||Download|
|MS||Roll-Gerotor||80,5-564,9||Up to 200||Up to 810||Up to 580||Download|
|MT||Roll-Gerotor||161,1-725||Up to 200||Up to 625||Up to 1250||Download|
|MV||Roll-Gerotor||250-510||Up to 200||Up to 510||Up to 1880||Download|